Which command would you use from the DSP to trigger a control system for camera tracking ?

• Related Articles

• Is it possible to do camera tracking through using the BFMA mics and the Converge Pro 2 DSP ?

  Camera tracking with the Converge Pro 2 DSP is possible using table top mics with the support of an external control system, but it is not possible with the BFMA or BMACT.

• Procedure to connect through telnet of the DSP and Command to factory reset the DSP.

  Connect the DSP to telnet through USB(169.254.99.202) or through LAN(user defined IP Address) at port 23.Use username:clearone,Password:converge.Enter "FACTORYDEFAULT" to factory reset the DSP.

• Beamforming mic signal not passing beyond post gate of the DSP (Converge Pro 880T)

  1) Check the cable connectivity between the DSP and the BFM for loose connections. 2) Upgrade the DSP and BFM to latest Firmware version 4.4 3)There may be a memory error in the DSP: Default the DSP through Telnet using the command is #**Default. ...

• Can I use the WS800 system with only the diplole antennas ?

  We always recommend that you use ceiling mount or mic stand mount (Powered) extension antennas. There are however some exceptions: 1. Less than 4 transmitters 2. Must be line of site. 3. Must be a huddle space or small conference room. 

• Can we assign an IP address to the DANTE Ports of the DSP ?

  The Dante ports IP Address is auto assigned and we cannot assign an ip address.  The IP address can be viewed in the Dante control software or using telnet with the command -BOX BOXname DANTE IP_ADDRESS1