What does it mean when my WS800 Boundary transmitter flashes red and green in the charging dock ?

• Related Articles

• What does it mean when my WS800 Podium or Boundary transmitter LED flashes red ?

  This indicates that the batteries are depleted and need recharged. It could also indicate a bad battery cell. 

• How do I sync My WS800 transmitter to my receiver ?

  Turn on your transmitter and locate the IR sensor on the transmitter. ( It is located on the rear of the Podium and Boundary transmitter, on the inside of the battery compartment on the Handheld and the beltpack transmitter). Aim the IR sensor at the ...

• How long does it take to charge the batteries in a WS800 and Dialog 20 transmitter ?

  It takes about eight hours to fully charge a Handheld, Beltpack and Boundary transmitter and about twelve to fourteen hours to fully charge a podium cassette.

• Why does my WS800 boundary audio sound low ?

  With the boundary transmitters you will want to give it a bit of pregain. This can be done by using the WS800 and Dialog 20 remote software. It is under the TX Audio Gain setting. We recommend +15 to +20dB of gain.  You will need to resync the mic on ...

• Fan status LED on Converge Pro 880TA is red

  The red Fan status LED indicates a hardware problem and the device will need to be replaced.