What does the Converge Pro 2 Front LED indicate ?

• Related Articles

• Fan status LED on Converge Pro 880TA is red

  The red Fan status LED indicates a hardware problem and the device will need to be replaced.

• Can we used a Converge Pro 2 with a Cisco Phone by using the Cisco breakout box like we use in Converge Pro 1 ?

  No, the Cisco Breakout box is not recommended for the Converge Pro 2

• Can the Huddle be controlled using the same serial commands as used for Converge Pro 2 ?

  Yes, the Huddle can be controlled using the same serial commands as used for converge pro 2

• Is it possible to do camera tracking through using the BFMA mics and the Converge Pro 2 DSP ?

  Camera tracking with the Converge Pro 2 DSP is possible using table top mics with the support of an external control system, but it is not possible with the BFMA or BMACT.

• The Converge Pro 2 Status LED is red which indicates a boot up problem, how can this be resolved ?

  1) First try a hard reset procedure - remove all of the input/output cables, and leave only the power cord connected.  Remove and reinsert all the cables after 30 minutes and check to see if the issue is resolved.    2) Connect to the serial (RS232) ...