What do the red LED's indicate on the WS800 extension antennas ?

• Related Articles

• Fan status LED on Converge Pro 880TA is red

  The red Fan status LED indicates a hardware problem and the device will need to be replaced.

• What does the Converge Pro 2 Front LED indicate ?

  Status LED: • Off: Unit still initializing • Blue - Fast Blinking: Stack Syncing in progress • Blue - Slow Blinking: Unit not configured • Blue - Solid: Configured unit • Red - Fast Blinking: Stack Sync error

• What does it mean when my WS800 Podium or Boundary transmitter LED flashes red ?

  This indicates that the batteries are depleted and need recharged. It could also indicate a bad battery cell. 

• Can I use the WS800 system with only the diplole antennas ?

  We always recommend that you use ceiling mount or mic stand mount (Powered) extension antennas. There are however some exceptions: 1. Less than 4 transmitters 2. Must be line of site. 3. Must be a huddle space or small conference room. 

• The Converge Pro 2 Status LED is red which indicates a boot up problem, how can this be resolved ?

  1) First try a hard reset procedure - remove all of the input/output cables, and leave only the power cord connected.  Remove and reinsert all the cables after 30 minutes and check to see if the issue is resolved.    2) Connect to the serial (RS232) ...