Is it possible to do camera tracking through using the BFMA mics and the Converge Pro 2 DSP ?

• Related Articles

• Which command would you use from the DSP to trigger a control system for camera tracking ?

  GATEREPORT is the command to use from DSP from the control system for camera tracking

• Can the Huddle be controlled using the same serial commands as used for Converge Pro 2 ?

  Yes, the Huddle can be controlled using the same serial commands as used for converge pro 2

• Can we used a Converge Pro 2 with a Cisco Phone by using the Cisco breakout box like we use in Converge Pro 1 ?

  No, the Cisco Breakout box is not recommended for the Converge Pro 2

• Beamforming mic signal not passing beyond post gate of the DSP (Converge Pro 880T)

  1) Check the cable connectivity between the DSP and the BFM for loose connections. 2) Upgrade the DSP and BFM to latest Firmware version 4.4 3)There may be a memory error in the DSP: Default the DSP through Telnet using the command is #**Default. ...

• The Converge Pro 2 Status LED is red which indicates a boot up problem, how can this be resolved ?

  1) First try a hard reset procedure - remove all of the input/output cables, and leave only the power cord connected.  Remove and reinsert all the cables after 30 minutes and check to see if the issue is resolved.    2) Connect to the serial (RS232) ...