I updated firmware on my Converge Pro 2 unit and now I cannot connect.

• Related Articles

• I updated the firmware on my Converge Pro 2 and now I can't see it to connect to it.

  Check the version of the console software you are using then use the Check for Updates tool in the Help menu to see what the newest console software version is.  Likely you just need to use a newer version of the console software to find it again.

• Can we used a Converge Pro 2 with a Cisco Phone by using the Cisco breakout box like we use in Converge Pro 1 ?

  No, the Cisco Breakout box is not recommended for the Converge Pro 2

• Can the Huddle be controlled using the same serial commands as used for Converge Pro 2 ?

  Yes, the Huddle can be controlled using the same serial commands as used for converge pro 2

• Is it possible to do camera tracking through using the BFMA mics and the Converge Pro 2 DSP ?

  Camera tracking with the Converge Pro 2 DSP is possible using table top mics with the support of an external control system, but it is not possible with the BFMA or BMACT.

• What does the Converge Pro 2 Front LED indicate ?

  Status LED: • Off: Unit still initializing • Blue - Fast Blinking: Stack Syncing in progress • Blue - Slow Blinking: Unit not configured • Blue - Solid: Configured unit • Red - Fast Blinking: Stack Sync error