Can we assign an IP address to the DANTE Ports of the DSP ?

• Related Articles

• Procedure to connect through telnet of the DSP and Command to factory reset the DSP.

  Connect the DSP to telnet through USB(169.254.99.202) or through LAN(user defined IP Address) at port 23.Use username:clearone,Password:converge.Enter "FACTORYDEFAULT" to factory reset the DSP.

• The DSP can be accessed through Telnet but we are unable to access the DSP through the Console software.

  1) Confirm that the DSP firmware and Console software are compatible 2) The following ports need to be open in the Laptop to connect through Console:  FTP port 21, and UDP port 3602, Discovery (already open since they can discover)

• Do the Beamforming MIc Array or BMA CTs units use Dante?

  No, all of our Beamforming Mic Array units, inluding the BMA CT, communicate using our proprietary P-Link protocol and do not use Dante.

• How to access DSP if password is changed and forgotten

  If the password has been forgotten, the DSP needs to be factory reset through with the serial port as the serial port does not require a username/password.  Connect through serial port (Baudrate:57600) to the DSP and send FACTORYDEFAULT * or Letter ...

• Which command would you use from the DSP to trigger a control system for camera tracking ?

  GATEREPORT is the command to use from DSP from the control system for camera tracking