Can the Huddle be controlled using the same serial commands as used for Converge Pro 2 ?

• Related Articles

• Can we used a Converge Pro 2 with a Cisco Phone by using the Cisco breakout box like we use in Converge Pro 1 ?

  No, the Cisco Breakout box is not recommended for the Converge Pro 2

• Is it possible to do camera tracking through using the BFMA mics and the Converge Pro 2 DSP ?

  Camera tracking with the Converge Pro 2 DSP is possible using table top mics with the support of an external control system, but it is not possible with the BFMA or BMACT.

• Can Huddle be used for USB 2.0 connectivity to PC and how about the quality of audio/Video ?

  Yes, the Huddle can be used for USB 2.0 connectivity.  Audio will not be affected and will be same as USB 3.0 connectivity.  Video will be affected in comparison to USB 3.0 and will be reduced to 720p in USB 2.0

• The Converge Pro 2 Status LED is red which indicates a boot up problem, how can this be resolved ?

  1) First try a hard reset procedure - remove all of the input/output cables, and leave only the power cord connected.  Remove and reinsert all the cables after 30 minutes and check to see if the issue is resolved.    2) Connect to the serial (RS232) ...

• Beamforming mic signal not passing beyond post gate of the DSP (Converge Pro 880T)

  1) Check the cable connectivity between the DSP and the BFM for loose connections. 2) Upgrade the DSP and BFM to latest Firmware version 4.4 3)There may be a memory error in the DSP: Default the DSP through Telnet using the command is #**Default. ...